Vertiv | NetSure™ 8200 Series -48 VDC Power System Installation Manual (IM582140000) | Rev. A
Re-Install Shields and Cover Panels
1. Replace all shields and cover panels that were removed when performing the procedures in this section.
Specifically…
• Replace front rectifier mounting position blank cover panels (only for mounting positions NOT to be
populated with rectifiers). To do so: Secure the cover panel with the two screws removed earlier.
Use the supplied grounding washers at both locations, per cover panel.
• Replace the three rear cover panels to each power/distribution bay and power only bay. To do so:
Lower Panels: Secure the cover panels with the screws removed earlier. Use the supplied
grounding washers at all locations. Top Panel: Place the keyhole slots in the cover panel over the
screws in the bays, slide the cover panel down and secure by tightening the screws.
• Replace the two rear cover panels to each distribution only bay.
• Ensure side cover panels are installed on end bays.
• Lists 102 and 112 only: Replace the front cover panel to each PDSC. To do so: Secure the cover
panel with the eight screws removed earlier. Use the supplied grounding washers at the top left
and bottom right locations.
• Lists 102 and 112 only: Replace the rear lower cover panel to each PDSC. To do so: Secure the
cover panel with the six screws removed earlier. Use the supplied grounding washers at the top left
and bottom right locations.
• Lists 102 and 112 only: Replace the rear upper cover panel to each PDSC. To do so: Place the
keyhole slots in the cover panels over the screws in the PDSCs, slide the cover panels down and
secure by tightening the screws. Use the supplied grounding washers at the top left and bottom
right locations.
2. For bays with PDSCs, install the bay-to-bay busbar link cover shield.
To Next Page
Loading...
Need help?
General
