300004969171/B Page 49 of 148
Figure 20: Home Tab Showing Live Imaging
Adjust the Image (if desired)
Your system’s image settings will be set to the default values recommended by the
manufacturer. These settings can be adjusted based on your preferences. Once set,
specific values persist until changed.
To change the settings, press the Adjust Image button. The Adjust Image dialog appears
at the bottom of the screen.
NOTE: You need to be sure that the image is set up properly before recording because
you will not be able to change the values for gain and diameter during the video loop
recording process.
To Next Page
Loading...
General