Page 92 of 148 300004969171/B
Chapter 13: Switching Modes
Overview
This chapter describes how to switch between available modalities.
Entering Patient Information
If planning to use more than one mode for a single patient, enter the patient information
in the IVUS modality before switching modes.
Switching Modes
You can switch from one modality to another by clicking on the Select Mode button
shown below. Once selected, a menu of available modes is presented. Click on the
modality to be redirected to that modality. If leaving an IVUS open case containing
images, the operator is prompted to continue with the current patient. Select Yes to
continue with the same patient. Select No if beginning a case with a new patient.
Figure 51: Select Mode Button
To Next Page
Loading...
General