5-18 BA 357-00 * 3.0 * 35700_05_Bedienung.fm
5 Operation
Machine stopping/securing
1. Remove dirt from the machine.
2. Stop the machine smoothly by releasing the accelerator pedal and
pressing the brake pedal.
3. Apply the parking brake – see "Parking brake" on page 5-6.
4. Move the travel direction lever to neutral.
5. Switch off all additional control circuits.
6. Set all switches and control levers to the zero position.
7. Lower the loader unit completely, extend the attachment horizontally
with the ground, and lower it. Operation
– see "Control lever (joystick) overview" on page 5-32.
8. Release the pressure in the hydraulic system
– see "Pressure relief – plug couplings" on page 5-33.
9. Actuate motor isolating switch
– see chapter 4 “Motor isolating switch” on page 4-22.
10.Turn the machine off and remove the ignition key.
➥ The immobilizer (opt) is enabled.
11.Perform a visual check for leaks and damage.
12.Close and lock the door and the windows.
Additionally on slopes:
13.Take additional measures to secure the machine by placing chocks A
under the downhill sides of the wheels.
➥ The wheel chock is located on the left on
the frame in front of the cabin.
14.Review “Parking” checklist on page 4-48.
To Next Page
Loading...
Need help?
General
