BA 357-00 * 3.0 * 35700_05_Bedienung.fm 5-103
Operation 5
Low-speed control with regulated travel speed (opt)
Important information on the low-speed control with regulated
travel speed (CSD = Constant Speed Drive)
Using this function, an even driving speed can be achieved. The selected
driving speed is largely self-contained of the driving resistance.
When operating hydraulically enabled attachments (e.g. sweepers or
ground mills), the function of the low-speed control ensures an even
driving speed or starting from a standstill with a high engine speed.
With the slide control 76 the driving speed can be variably set.
The low-speed control can be used in connection with the option oil
volume adjustment – see "Oil volume setting" on page 5-36.
To achieve maximum travel speed in normal operation the
slide switch 76 must be pushed forward to the limit (A).
The travel speed that was chosen with the low-speed control, can be
briefly increased using the accelerator pedal. To do this, push the
accelerator pedal all the way down. After releasing the accelerator pedal,
the machine will brake to the chosen driving speed again.
As soon as the service brake is actuated,
• the low-speed control feature in speed range "turtle" is briefly
deactivated, but is activated again with the same setting as soon as the
service brake is released.
• the low-speed control is always deactivated in speed range "hare" and
must be activated again.
To Next Page
Loading...
Need help?
General
