BA 357-00 * 3.0 * 35700_06_Transport.fm 6-9
Transport 6
Loading process
Risk of injury due to falling machine or parts of it!
Falling objects can cause serious or fatal injury.
► Use tested, intact lifting gear of sufficient dimensions.
► Check that the lifting gear is safely fastened.
► Ensure that nobody remains under the raised machine.
The crane chains can damage the machine when it is raised.
► Before raising the machine, protect it against damage with a suitable
protection between the crane chains and the machine.
1. If necessary, install standard bucket.
2. Empty and tilt in the standard bucket, and lower it to transport position
– see chapter 4 “Raising the attachment to transport position” on
page 4-52.
3. Set the drive to a neutral position – see chapter 5 “Slowing the
machine and stopping” on page 5-15.
4. Apply the parking brake
– see chapter 5 “Parking brake” on page 5-6.
5. Turn the machine off and remove the ignition key.
6. Disconnect the battery connector.
7. Close the cabin and battery cover plate securely.
8. Fasten sufficiently sized lifting gear to the 4 slinging points (symbol A
on the frame) of the vehicle.
9. Carefully raise the machine with the crane.
The slinging points B on the cabin may only be provided for the
disassembly of the cabin and may not be used for loading the vehicle.
To Next Page
Loading...
Need help?
General
