7-64 BA 357-00 * 3.0 * 35700_07_Wartung.fm
7 Maintenance
Machine fuses
Blown fuses indicate overloading or short circuits of an electrical
component.
► If a fuse blows out again shortly after replacement, have the electrical
system checked by an authorized service center before installing a
new fuse.
► In order to avoid damage to the electrical system, use only fuses of the
specified load capacity (amperage).
The use of incorrect fuses is a fire hazard and risks damaging
components!
The use of incorrect fuses can damage the electrical system and result in
fires. The safety and functionality of the machine is no longer guaranteed
if incorrect fuses are used.
➥ Only use fuses with the specified rated value
– see chapter 9 “Fuse panel” on page 9-11.
Master fuse
The master fuse A is located on the motor isolating switch.
Accident hazard due to high electrical voltages!
Improper performance of work on the electrical system can result in
serious injury or death.
► Only persons who have received additional training as an "Expert for
Work on HV Machines" (DGUV Information 200-005) are permitted to
work on the master fuse in Germany. Be aware of, observe and comply
with the corresponding legal regulations of other countries.
To Next Page
Loading...
Need help?
General
