WAGNER PROTEC 95-150 - 8 Cleaning and Maintenance; Cleaning; Cleaning Personnel; Decommissioning and Cleaning

41
VERSION 01/2020
ORDER NUMBER DOC2340282
IceBreaker 150-300 cm
3
8 CLEANING AND MAINTENANCE
8.1 CLEANING
8.1.1 CLEANING PERSONNEL
Cleaning work should be undertaken regularly and carefully by qualied and trained
personnel. They should be informed of specic hazards during their training. The following
hazards may arise during cleaning work:
− Health hazard from inhaling solvent vapors.
− Use of unsuitable cleaning tools and aids.
8.1.2 DECOMMISSIONING AND CLEANING
The device should be cleaned for maintenance purposes, etc. Ensure that no remaining
product dries on and sticks to the device.
Procedure
1. Carry out work interruption Chapter 7.4.
2. Carry out the basic ushing Chapter 7.5.
3. Empty system in a controlled manner Chapter 8.2.4.
4. Service spray gun in accordance to its operating manual.
5. Clean and check the suction system and the suction lter.
6. When using a product lter, check lter insert and lter housing and clean or replace
them. Chapter 8.2.6
7. Clean the outside of the system.
8. Fully assemble the system.
9. Check ll level of the separating agent Chapter 8.2.3.1.
10. Fill the system with ushing agent in accordance with Chapter 8.2.5.
8.1.3 LONGTERM STORAGE
When storing the device for longer periods of time, it is necessary to thoroughly clean it
and protect it from corrosion. Replace the water or solvent in the product pump with a
suitable preservative, ll separating agent cup with separating agent.
Procedure
1. Perform points 1 to 8 in Chapter 8.1.2.
2. Fill the system with preservative in accordance with Chapter 8.2.5.
3. Empty the system in a controlled manner in accordance with Chapter 8.2.4 and seal
the openings.