9
VERSION 01/2020
ORDER NUMBER DOC2340282
IceBreaker 150-300 cm
3
2.4 PROCESSIBLE WORKING MATERIALS
Fluid materials like paints and lacquers.
Application
Water-dilutable products
Solvent-based products
Primers
Epoxy and polyurethane lacquers, phenolic
lacquers
Underside protection, re protection materials
recommended limited suitability not suitable
NOTICE
Abrasive working materials and pigments!
Greater wear of product-wetted parts.
Use the application-oriented model (ow rate/cycle, product, valves, etc.) as
indicated in Chapter 5.5.
Check if the uids and solvents used are compatible with the pump construction
materials as indicated in Chapter 5.5.1.
Use suitable device combinations (packings, valves etc.)
Wear caused by abrasive working materials is not covered by the warranty.
Typical applications
Application
Steel-processing industry
Rail vehicle
Shipbuilding
Tank construction
Pipeline construction
Wind energy
recommended limited suitability not suitable
MISUSE
Misuse can lead to physical injury and/or property damage!
Special attention must be paid that:
No dry coating products, e.g., powder are processed.
no food, medicine or cosmetics are processed.
It is important to note that the device's materials are not food-safe.
To Next Page
Loading...
