Wavetronix SmartSensor HD - Page 84

Chapter 7: Verifying Lanes
•
83
Setting Description Details
Direction Protection Determines whether
the software reports
or ignores any
vehicles that are
traveling the opposite
direction in a given
lane. For example, if
this is turned on, and
if a lane is configured
as moving left to
right, then any traffic
moving right to left
will be ignored (it
won’t be shown
on the Verification
screen—though it
will be shown on
the Configuration
screen—and it won’t
be counted).
By default, Direction
Protection is turned
on for each lane
(although if you set a
lane as bi-directional,
this setting is turned
off and can’t be
turned back on from
here—you’ll have
to go back to the
Configuration screen).
Having it on can be
useful if, for instance,
the sensor’s in an
area where work
vehicles often go the
wrong direction up
the road. You’ll need
it off, however, to do
wrong-way detection.
Set Defaults Returns all the
settings for this lane
to the defaults.
N/A
Note. If Direction
Protection is on,
wrong-way vehicles
will not be shown
moving across the
Verification screen.
However, they will
still be shown on the
Configuration screen.