Page 105 of 127
13.7 HMI-Update
A HMI-Update of the system unit will be realized with a new
software version automatically and must be confirmed by the
iLOGIK.
A HMI-Update without software update is realized as follows:
1. Insert the USB-Stick with the new HMI data.
2. Switch the system on and keep the iLOGIK pressed by
appearance of the program version.
3. On the display is shown:
Copy HMI-Data
From stick?
4. Confirm by touching the iLOGIK.
5. Wait till “ready”.
6. Start the system with a short pressure at the iLOGIK.
To Next Page
Loading...