Page 81 of 127
10 Faults
The following chapter describes possible causes of malfunctions
and how to remedy these.
In case of frequent faults, reduce the service intervals depending to
the actual work load.
Please contact your local distributor with regard to faults that
cannot be remedied with the information provided below.
10.1 Safety
The fault remediation work described here, unless specified
otherwise, can be performed by the operator.
Some tasks may only be performed by specially trained
specialised staff or exclusively by the manufacturer; this is
specifically pointed out in the description of the individual faults.
Work on the electrical system may only be performed by
electricians.
DANGER!
Danger to life through electric shock!
Danger to life if live components are touched.
Electrical components that are switched on may
execute uncontrolled movements and cause
severe injury.
Therefore:
– Before starting any work, switch off the power
supply and pull the mains plug.
Improper fault remediation
WARNING!
Risk of injury by improper fault remediation!
Improper fault remediation may cause severe injury
to persons, or material damage.
Therefore:
– Ensure adequate working space before starting
any work.
– Keep the working area clean and tidy! Loosely
stacked or scattered components and tools are
potential causes of accidents.
To Next Page
Loading...