Print direction indicates the direction of movement of the product on the
conveyor belt viewed from the controller in the print direction
Contrast of the print image. If necessary this parameter must be changed to
optimize the print image. A higher intensity gives greater blackening and longer
ink drying time
Print speed = Speed of the conveyor. The speed of the conveyor must be
keep constant
Offset print, i.e. by how much is printing delayed in millimetres after the
product is detected by the light barrier.
The number of pixel can be increased or decreased using this parameter.
The print image becomes narrower or wider.
A sensor for the detection of the product. Mostly used are optical sensors
(photo sensor, light barrier, reflex sensor)
If a shaft encoder is connected to the controller, the print speed is
automatically matched to the conveyor belt speed through the impulses of
the rotary encoder
Thermal Ink JET print function of the HP cartridges
To Next Page
Loading...