Weber Markoprint iJET - Page 89

Art. No.: 72801001
List of accessories and spare parts
Page 89 of 127
NOTE!
After the insertion of a new cartridge the ink
counter must be reset and the temperature
measurement must be calibrated.
Ink level:  Chapter 8.16, page 68
Temperature:  Chapter 8.19, page 69
The settings can be made with the iDesign software below
Functions / System settings / Advanced settings.
No.
Name
Description
Order no.
1
HP-Set 4 STABL
2x ink cartridges, colour black, volume each 42 ml.
Specially developed, highly pigmented HP ink.
Well suited for sharp edged print on absorbent materials.
Drying:
Good on absorbent surfaces; ink does not dry on semi
absorbent surfaces since the pigments remain on the surface.
Open time without loss of quality:
Approx. 15 minutes (depending on print resolution and print
image).
Delivered as SmartCard cartridge.
72500013
2
HP Set 12 UVINV
2x print cartridges, colour transparent, volume each 42 ml.
Specially developed HP ink, readable under UV light.
Well suited for sharp edged print on poorly absorbent materials.
72500021
3
HP Set 14 MIBL 2
2x print cartridges, colour black, volume each 42 ml.
Specially developed, solvent-containing, pigmented HP ink.
Well suited for sharp edged print on lacquered materials.
72500023
4
HP Set 26 RCBLU
2x print cartridges, colour blue, content per 42 ml.
Specially developed, solvent-containing HP ink.
Well suited for printing on poorly absorbent material.
Drying:
On poorly absorbent surfaces within a few seconds, on
absorbent surfaces immediately. Good marginal sharpness on
poorly absorbent surfaces.
Open time without loss of quality:
Up to 2 hours (depending on intensity and print image).
72500036