Weber Markoprint iJET - Page 96

Art. No.: 72801001
Appendix
Page 96 of 127
If a print label without saved parameter is selected, the last settings
will be used. After changes were made to the parameter, this can
saved to the print label, as described below. The next time the print
label is selected, it will be print with the saved parameter.
Instruction
Please save the set parameter values to a print label as follows:
Step
Procedure
1
Touch the iLOGIK in one of the status menu.
 The print image submenu is displayed.
2
Call the Settings submenu by rotating the iLOGIK and select it by pressing.
3
Call the Save parameter submenu by rotating the iLOGIK and select by
pressing.
4
The actual set parameter will be saved to the selected print label by rotating
the iLOGIK and confirm it by pressing.