Wega Wegaconcept

43
Wegaconcept
Technical manual
ENGLISH
i
In the even you want to program the stand by
periods, and/or rest periods of the machine, set
the time to 00:00.
28.9 Conguration of groups proper use
To congure proper use of the single delivery groups,
proceed as follows:
ENTER
(x 5 secs.)
Hold down the ENTER button for at least 5 seconds.

Scroll the menu until the item is highlighted
05 ENERGYSAVE TIMING
06 WORKING MODE
07 STBY MODE
08 AUTOSTEAMER MODE
ENTER Conrm to access the menu
SET ON/STBY/OFF
GR.1 XXX

Set the operating mode of group 1: ON always active,
STBY, cong. stand-by, OFF always inactive

Conrm and go to next group Repeat the operation for
each delivery group.
Once the last group has been set, the display will show
the Energy Saving settings
SET ON/ESAV/OFF
REST XXX

Set the machine stand-by mode: ON machine always
on, ESAV set on Energy Saving, OFF completely turned
o.

Conrm and move to the next screen.
REDUCED SETPOINT
STBY TEMP. XXX.C

Set the temperature of the groups in the stand-by
phase

Conrm and go to programming of the temperature of
the entire machine in the energy saving phase (only if
set)
Time of the second stand-by period of the delivery groups:
STANDBY 2 TIME
FROM HR:MN

Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the () key.

Once the minutes (MN) are set, press ().
STANDBY 2 TIME
TO HR:MN

Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the () key.

Once the minutes (MN) are set, press ().
Programming the energy saving time of the machine.
Time of activation of machine Energy Saving
REST TIME
HR:MN

Set the start time for stand-by. To switch from hours
(HR) to minutes (MN) press the () key.
ENTER Conrm to exit the menu.
05 ENERGYSAVE TIMING
06 WORKING MODE
07 STBY MODE
08 AUTOSTEAMER MODE

To exit the programming menu