50
Wegaconcept
Technical manual
i
To perform cleaning operations, proceed as
indicated in chapter " Group washing". When
the machine is turned on, after the temperature
raises to operating levels, if set to YES, the display
shows the washing request. to disable the washing
request, set time to 00:00.
28.18 Programming group washing
To program the automatic notication of delivery
group washing request proceed as follows:
ENTER
(x 5 secs.)
Hold down the ENTER button for at least 5 seconds.
Scroll the menu until the item is highlighted
13 NEW PROGRAM
14 DELIVERY TEST
15 GROUP WASHING
16 NUMBER OF GROUPS
ENTER Conrm to access the menu
START ON WASHING
YES/NO
Enable or disable the request for automatic washing of
the groups at machine start-up
Conrm pressing () to move to the next screen.
WASHING TIME/CYCLO
HH:MM N=X
Set the requested time for the washing of the groups
Move on to the next item.
Set the number of washing cycles ON-OFF (X).
ENTER Conrm to exit the menu.
13 NEW PROGRAM
14 DELIVERY TEST
15 GROUP WASHING
16 NUMBER OF GROUPS
To exit the programming menu
Display the following screen as previously indicated.
WASHING TIME/CYCLO
HH:MM N=X
Repeatedly press the button () until the following
screen appears.
TOTAL WASHES
ZZZZZZZZ
Reset of the counter is carried out by pressing the but-
ton ().
RESET WASHES
PRESS ^KEY 3 SEC
To reset, hold down the button () for at least 3
seconds.
Counting and reset of groups washes
It is possible to read the number of wash cycles
executed since the last reset operation, proceeding as
follows:
The eld marked with the letter "Z" indicates the
number of washes executed since the last reset.
To reset the washes counter, proceed as follows:
Once the procedure is concluded the program returns
to the main programming menu.
To Next Page
Loading...
