WEIHONG 200 Series Manufacturer's Manual

上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
- 104 - Specialized, Concentrated, Focused
Type
Warning Content
Cause
Solution
Related
errors of
state
The system is busy,
this operation can‘t
be executed.
Some illegal operations are
performed under machining
state.
Stop machining, and execute
some operations under idle
state.
Please exit from
simulation mode in
the status page
before changing the
state!
It is possible that some
illegal operations are
performed under simulation
mode, like modifying a
parameter or pressing some
shortcut keys.
Stop simulation and execute
some operations under idle
state.
Please switch to Auto
mode first.
Perform some operations
only available under Auto
mode in Manual and
Reference Point modes, like
pressing ―Program Start‖
under Manual mode.
Switch to Auto mode and
then perform the
corresponding operation.
Breakpoint resuming
can‘t be executed
under current state.
―Breakpoint Resuming‖
button is pressed in the
process of machining.
Breakpoint resuming can be
performed to continue
machining in case of power
failure, manually pressing
―Program Stop‖ button, and
E-stop in machining.
File
error
There is no file
loaded in the current
parser.
Start file machining with no
file loaded in the system.
Load a machining file before
start machining.
Failed to read the
machining file, and
check if the path of
this file is changed.
The file loaded originally is
deleted.
It is necessary to re-load the
machining file.

WEIHONG 200 Series Specifications

General

Brand	WEIHONG
Model	200 Series
Category	Control Systems
Language	English