上海维宏电子科技股份有限公司
Weihong Electronic Technology Co., Ltd.
Specialized, Concentrated, Focused - 77 -
3.15 System Management
3.15.1 System Info
As shown in Fig. 3-53, view the related information (including CNC software information and CNC
hardware information) of NcStudio in [System Info (C)] screen of [System] function area. Pressing letter
key C will enter [System Info] function screen.
Fig. 3-53 System info screen
3.15.2 Network Connection
NK280 supports network connection. For details, refer to chapter 3.16.
3.15.3 Language
Press F3 under [System Info] sub-function screen of [System] function area to switch between
languages. To validate the language switching, it is necessary to reboot the system.
3.15.4 Register
In [System Info] screen of [System] function area, ―registration code‖ can be used to register the
system and limit the system service time. Registration code is generated by registration code maker. Its
generation steps are:
1) Learn the info of board card no. in [System Info (C)] of [System]. See Fig. 3-53.
2) Double click the registration code maker ―GetRegCode.exe‖, and then enter the password
―ncstudio‖ (revisable) in the dialog box as shown in Fig. 3-54. Then press ―OK‖, input board card no.,
registered times and limited service time, and then click ―Generate‖ to generate the new code
displayed at the lower part, as shown in Fig. 3-55. If service time does not need limiting, input ―-1‖ in
the ―limited time‖ bar to generate an unlimited code.
To Next Page
Loading...
Need help?
General
