Window Master FlexiSmoke WSC 520 - 14.2 Motor line; 14.2.1 Motor line - numbering; 14.2.2 Motor line - configuration

34
14.2 Motor line
Motors are to be connected on the motor lines.
Depending the type of module either ±24V standard motors or motors with MotorLink
®
can be connected.
14.2.1 Motor line - numbering
All motor lines are numbered and they are all to be configured.
14.2.2 Motor line - configuration
Press ”Motor line” and the overview of the motor lines in the smoke ventilation panel is shown.
Overview configuration motor lines
One motor line is marked with a
as the configuration is missing.
All motor lines are configured.
All motor outputs on the motor module as well as the single motor output S1.X1 on the WSA 5PS module are to be configured:
- Motor lines with motors connected are to be configured in “motor group
-
- Motor lines with no motor connected are set to “none“
Since ±24V motors and motors with MotorLink
®
are not to be configured exactly the same way, both type of motors are listed below
with the settings that are to be configured for each motor type.
Be aware that both types of motors can be connected to the smoke panel at the same time. ±24V motors can be connected in the
modules WSA 5PS and WSA 5SM and motors with MotorLink
®
can be connected on the module WSA 5ML.