Window Master FlexiSmoke WSC 520 - 14.8 Weather station type; 14.9 Sequence control

43
14.8 Weather station type
Here is to be selected which type of weather station – none, WOW or WLA – that is connected.
(The menu “Weather station” is only used for input from WSA 5MC input S2X3.2. If WLA 340 is selected a wind speed (pulse) signal is
received from the WLA 340. If WOW is selected a wind speed and wind direction (serial communication) signal is received from WOW
201/202. See section 10.2 in the installation instruction).
WLA 33x is not a weather station and is connected directly to an input, see section 14.6.3
Weather station - configuration
Overview ’Sensor type’
Overview ’Sensor type’ (selection of type of weather station)
Weather station shall be configured in:
Configuration of the sensor
None
(no configuration)
WOW
1. Filter constant
2. Slow filter constant
3. Use RMS in filter
4. Retransmit time
The appendix contains all the items that can be configured - see
appendix for detailed explanation.
WLA
1. Pulses/sec. per m/s
2. Filter constant
3. Slow filter constant
4. Use RMS in filter
5. Retransmit time
The appendix contains all the items that can be configured - see
appendix for detailed explanation.
14.9 Sequence control
The sequence control functionality is used where the movement of a motor line must depend on an external event or situation/stage.
To be used where window flabs are overlapping or where the windows cannot open (e.g. more than 15%) if the blinds are down a.s.o.
The sequence control can be controlled depending on;
- the position of a different motor line
- the state of a local input
- the state of a KNX object
- the state of a BACnet object
Sequence control configuration
Activation of sequence control
The activation of sequence control is to be done for each motor line.