Manual 26166V1 MicroNet Simplex & MicroNet Plus
Woodward 10
For ATEX compliance, this equipment must be protected externally against transient disturbances.
Provisions shall be made to prevent the power input from being exceeded by transient disturbances of
more than 40% of the rated voltage.
Personnel must discharge their electrostatic build up to the cabinet ground point or use an ESD strap
prior to touching the MicroNet or modules if the engine/turbine is operational.
CPU modules contain internal energy limited circuits. These circuits have no external connections and
are not affected by module loading.
CPU modules contain single cell primary batteries. These batteries are not to be charged and are not
customer replaceable.
For environmental specifications, please refer to the appropriate appendix in Volume 2 of this manual.
This equipment is considered indicator equipment and is not to be
used as metrology equipment. All measurements need to be verified
using calibrated equipment.
EXPLOSION HAZARD—Do not connect or disconnect while circuit is
live unless area is known to be non-hazardous.
Substitution of components may impair suitability for Class I,
Division 2 applications.
Do not remove or install power supply while circuit is live unless
area is known to be non-hazardous.
Do not remove or install modules while circuit is energized unless
area is known to be non-hazardous.
RISQUE D’EXPLOSION—Ne pas raccorder ni débrancher
tant que l’installation est sous tension, sauf en cas
l’ambiance est décidément non dangereuse.
La substitution de composants peut rendre ce matériel
inacceptable pour les emplacements de Classe I,
applications Division 2.
Ne pas enlever ni installer l’alimentation électrique pendant
que le circuit est sous tension avant de s’assurer que la
zone est non dangereuse.
Ne pas enlever ni installer les cartes pendant que le circuit
est sous tension à moins de se trouver dans un
emplacement non dangereux.
To Next Page
Loading...
