Woodward MicroNet Simplex - Figure 4-10. Outline Drawing of Micronet 6-Slot I;O

Manual 26166V1 MicroNet Simplex & MicroNet Plus
Woodward 36
From a module connector standpoint, any I/O module can be installed in any of the slots designated for
I/O modules. However, when the application software is designed, each module will be assigned to a
specific slot and thereafter, the software will expect that specific I/O module to always be in its designated
slot.
Notes:
 Add ~2” (~5 cm) to the depth dimension to account for the cable saddles that are not shown on the
outline drawing below.
 The PE ground connection point is located underneath the left side of the chassis.
 To ensure compliance with the EMC certification, all chassis mounting screws (#8-32 M4) should be
installed to properly ground the chassis to the mounting plate.
 For proper airflow, the installation should allow a 3” (8 cm) air gap above and below the chassis.
Figure 4-10. Outline Drawing of MicroNet 6-Slot I/O
Released