Manual 26166V1 MicroNet Simplex & MicroNet Plus
Woodward 57
Figure 6-4. CPU Module
6.2.2—Module Configuration
Hardware Configuration. The Module Configuration Switch (S2) must be configured properly for CPU mode
(main rack, address 0x000) operation. This module will be factory configured appropriately.
Figure 6-5. Modular Configuration Switch (S2)
Network Type
Switch Function
OFF RTN Network 172.20.x.x
ON RTN Network 10.250.x.x
Module Config
Addr Switch Function
0 000 CPU, MAIN CHASSIS
1 001 RTN, CHASSIS-X1
2 010 RTN, CHASSIS-X2
3 011 RTN, CHASSIS-X3
4 100 RTN, CHASSIS-X4
5 101 RTN, CHASSIS-X5
6 110 RTN, CHASSIS-X6
7 111 RTN, CHASSIS-X7
*SWITCH POSITIONS SHOWN AT CPU DEFAULTS
Module Config
Switches
NETWORK
TYPE
S2
1 2
3
4
LSB
ON
(o
pen)
OFF
Figure 6-3. CPU_P1020 Module Hardware Configuration
Network Type. The Network Type setting is factory set OFF to automatically configure the RTN communication
port IP addresses to the 172.20.x.x series.
To Next Page
Loading...
