Xerox Phaser 3635 System Administration Guide 13
3 Network Installation
This chapter explains how to setup the machine to operate in the following environments:
• TCP/IP on page 13
• AppleTalk on page 20
• Netware on page 21
TCP/IP
These instructions show you how to configure the following via CentreWare Internet
Services:
• TCP/IP v4 and v6
• Domain Name
• DNS
• Zero Configuration Networking
The device supports TCP/IP versions 4 and 6. IPv6 can be used instead of or in addition to
IPv4.
IPv4 Settings can be configured directly at the device user interface, or remotely, via a web
browser using Internet Services. IPv6 can only be configured using Internet Services. To
configure TCP/IP Settings using CentreWare Internet Services, See Configure IPv4 or IPv6
Settings using CentreWare Internet Services on page 17.
Configure Static IPv4 Addressing using the Machine User Interface
Information Checklist
Before starting the installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
6. Host Name for the machine.
To Next Page
Loading...
