Windows Printing
Xerox Phaser 3635 System Administration Guide 43
Configure AppleTalk
1. At your workstation, open the Web browser and enter the TCP/IP address of the
machine in the Address bar.
2. Press [Enter].
3. Click on the [Properties] tab.
4. Click on the [Connectivity] link.
5. Click on the [Protocols] link.
6. Select [AppleTalk] in the directory tree.
7. Click the [Enabled] checkbox to enable the Protocol.
8. Type a name for the machine in [Printer Name].
9. Select the required [Zone].
10. Click [Apply] to accept the changes.
If prompted, enter the Administrator’s User ID [admin] and Password [1111], and
click on [Login].
11. The settings are not applied until you reboot the machine. Click the [Status] tab.
12. Click the [Reboot Machine] button and click [OK] to reboot the machine. The
network controller takes approximately 5 minutes to reboot and network connectivity
will be unavailable during this time.
Install the Printer Driver
1. Follow the steps below that are specific to your operating system:
Windows XP
a) Click on [Start].
b) Click on [Network Connections].
Windows 2000/2003
From the Desktop:
a) Right-click on the [My Network Places] icon.
b) Click on [Properties].
2. Right-click on the network connection you want to configure AppleTalk on, and then
click on [Properties].
3. The [Connection Properties] dialog box opens.
4. On the [General] tab, if the AppleTalk Protocol is in the list of installed protocols,
make sure that it is selected. If the AppleTalk protocol is not listed, install it using the
documentation provided by Microsoft, then return to this page.
5. Follow the steps below that are specific to your operating system:
Windows XP
a) Click on [Start].
b) Click on [Network Connections]
To Next Page
Loading...
Need help?
General
