3Network Installation
20 Xerox Phaser 3635 System Administration Guide
Zero-Configuration Networking:
• Self Assigned Address (IPv4) – Allocates an IPv4 address without using a DHCP
server. This check box is selected when [IP Address Resolution] is set to [Autonet].
This is a display-only item.
• Self Assigned Address (IPv6) – Displays “Enabled”. This is a display-only item.
AppleTalk
Information Checklist
Before starting the installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Existing operational AppleTalk network.
2. AppleTalk Name to assign to your printer.
3. AppleTalk Zone (if used) where your printer will reside.
Procedure
Setup AppleTalk at the machine
1. Press the <Log In/Out> button on the machine to enter the Tools Pathway.
2. Enter the Administrator’s Password. The default is 1111.
3. Touch [Enter].
4. Press the <Machine Status> button.
5. Touch the [Tools] tab.
6. Touch [Connectivity and Network Setup].
7. Touch [Advanced].
8. Touch [Network Setting].
9. Touch [Network Setup].
10. Touch [AppleTalk].
11. Touch [Protocol].
12. Touch [Enable].
13. Touch [Save].
14. Touch [Name and Area].
15. Touch [Printer Name].
16. Enter the name using the on screen keyboard. When you are finished, touch [Save].
17. Touch [Area Name].
To Next Page
Loading...
Need help?
General
