3Network Installation
22 Xerox Phaser 3635 System Administration Guide
7. Touch [Advanced].
8. Touch [Network Setting].
9. Touch [Network Setup].
10. Touch [NetWare].
11. Touch [Protocol].
12. Touch [Enable].
13. Touch [Save].
14. Touch [Frame Type].
15. Select the Frame Type desired by touching the frame type buttons, then touch
[Save].
16. Touch [NDS Settings].
17. Touch [Name Context].
18. A default name will appear.
Novell suggests using typeful names when entering Name Context and Directory
Service Tree information, for example:
cn=contextname.ou=organization.o=company.c=country.
19. Touch [abc] to switch between capitals and lowercase characters.
20. When you are finished, touch [Save].
21. Touch [Directory Service Tree].
22. Enter a directory tree and context for the machine in the NDS Tree Name and NDS
Context. When you have finished, touch [Save] twice to accept the changes.
23. Touch [Print Server].
24. Touch [Print Server Name] and use the touch screen keyboard to enter the name
you assigned to your print server. When finished touch [Save].
25. Touch [Print Server Password]. Use the on screen keyboard to enter the print server
password, in the correct case you recorded when you setup your print server and
touch [Save].
26. Touch [Save]
to exit the [Print Server] screen and accept your changes.
27. Optional Step:
• If you wish to change the desired SAP rate or Poll Interval for your printer or set
the Primary File Server, touch [Rates].
• Select the box under [Poll Interval] and enter the desired number from the
keypad. The default values are recommended. When you are finished, touch
[Save].
• Select the desired setting for the [SAP Rate] by touching the arrow buttons.
• Touch [Save] again.
28. Touch [Close] three times.
To Next Page
Loading...
