Safet
Xerox Color 550/560 Printer
User Guide
9
Electrical Supply
WARNING:
This printer must be connected to a protective earth circuit. This printer is supplied with a plug that has a
protective earth pin. This plug will only fit into an earthed electrical outlet. This is a safety feature. If you are
unable to insert the plug into the outlet, contact a licensed electrician to replace the outlet.
This printer shall be operated from the type of electrical supply indicated on the printer’s data plate label. If you are not
sure that your electrical supply meets the requirements, please consult a licensed electrician for advice.
Power Cord
Always connect equipment to a correctly grounded power outlet. If in doubt, have the outlet checked by a
qualified electrician.
Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have a ground
connection terminal.
Use the power cord supplied with your printer.
Do not use an extension cord or power strip.
Do not place objects on the power cord.
Do not place the printer in an area where people might step on the power cord.
The power cord is attached to the printer as a plug-in device on the back of the printer. If it is necessary to disconnect all
electrical power from the printer, disconnect the power cord from the electrical outlet.
The printer must be turned off before removing the power cord. For instructions on turning the printer off, see Turning
the Printer Off.
To Next Page
Loading...
Need help?
General
