General Setup
Xerox
®
B215 Multifunction Printer
User Guide
56
3. Select an option:
• Low Power Save: To specify how long the printer remains idle before it goes from ready mode
to Low Power Save mode, enter the minutes using the touch screen keypad. Touch
Confirm.
• Very Low Power Save: To specify how long the printer remains in Low Power Save mode
before it goes into Very Low Power Save mode, enter the minutes using the touch screen
keypad. Touch
Confirm.
Note: The sum of the two timers cannot exceed 119 minutes.
4. Touch X.
5. To return to the home screen, press the Home button.
Timers
Use the Timers settings to specify timeout periods for settings and configure Held Job settings.
1. At the printer control panel, press the Home button.
2. Touch Device
General
Measurements.
3. Select an option:
• System Timeout: To specify how long the system waits before resetting job settings, enter
the minutes using the touch screen. Touch
Confirm.
• Held Job Timeout: To enable this option, touch On. To specify the amount of time that the
printer holds a job for attention before it deletes the job from the queue, enter the minutes
using the touch screen keypad. Touch
Confirm.
4. Touch X.
5. To return to the home screen, press the Home button.
Measurements Settings
Set the measurements to display in inches or millimeters.
1. At the printer control panel, press the Home button.
2. Touch Device
General
Measurements.
3. Touch Inches or Millimeters.
4. To return to the home screen, press the Home button.
Setting Altitude Adjustment
Atmospheric pressure, determined by altitude, can affect print quality. If the printer is at an elevation
greater than 1000 m (3280 ft.), to improve print quality, you can use Altitude Adjustment.
1. At the printer control panel, press the Home button.
2. Touch Device
General
Altitude Adjustment.
3. Select an option:
To Next Page
Loading...
