Installing Optional Trays
CCaauuttiioonn:: To avoid the risk of electrical shock, if you are accessing the controller board or installing
optional hardware or memory devices sometime after setting up the printer, then turn the printer off, and
unplug the power cord from the electrical outlet before continuing. If you have any other devices attached
to the printer, then turn them off as well, and unplug any cables going into the printer.
1. Turn off the printer.
2. Unplug the power cord from the electrical outlet, then from the printer.
3. Unpack the optional tray, then remove all packing material.
4. Align the printer with the optional tray, then lower the printer into place.
CCAAUUTTIIOONN——PPOOTTEENNTTIIAALL IINNJJUURRYY:: If the printer weight is greater than 20 kg (44 lb), then it may
require two or more people to lift it safely.
Note: If you are installing any optional 550-sheet Trays, place them below the Optional 550+100-sheet Tray.
5. Connect the power cord to the printer, then to the electrical outlet.
CCAAUUTTIIOONN——PPOOTTEENNTTIIAALL IINNJJUURRYY:: To avoid the risk of fire or electrical shock, connect the power cord
to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.
6. Turn on the printer.
Add the tray in the print driver to make it available for print jobs. For more information, refer to Adding
Available Options in the Print Driver.
Xerox
®
C325 Color Multifunction Printer User Guide 95
Set up, Install, and Configure
To Next Page
Loading...
