Xerox Color C75 Press - Page 322

• Close the finisher cover(s).
2.
Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
012-264
Cause: Finisher jam or fault
Remedy: Perform the following:
1. If machine UI continues to reflect a fault/jam, go to the finisher:
• Open the finisher.
• Remove any jams
• Close the finisher cover(s).
2.
Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
012-302
Cause: Finisher jam or fault
Remedy: Perform the following:
1. If machine UI continues to reflect a fault/jam, go to the finisher:
• Open the finisher.
• Remove any jams
• Close the finisher cover(s).
2.
Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
013-100
Cause: Jam/fault with the SquareFold Trimmer Module
Remedy: Perform the following:
1. Open the Top Left and Right Covers of the SquareFold Trimmer Module.
2. Carefully remove all sheets and paper scraps from jam clearance areas.
3. Close the SquareFold Trimmer Module Top Left and Right Covers.
4. Check the Trimmer Waste Container:
• If full, empty the container and reinsert it into the SquareFold Trimmer Module.
• If the container is partially pulled out, push it completely in.
5. If necessary, follow any remaining instructions on the machine’s UI.
Xerox
®
Color C75 Press18-18
User Guide
SquareFold Trimmer Module