Service Call Procedures
Phaser 3100 MFP 04/08 1-7
SCP 3 Final Actions
After the machine has been re-assembled, perform the steps that follow:
1. Exercise the machine in all modes.
2. Make a proof copy or print of a customer document.
3. If any of the customers selections were changed, return them to the customers preferred set-
tings.
4. Mark off any hardware/software options and modifications installed and/or enabled in the
Service Log, GP 19.
5. At the first service and at any subsequent service where changes are made or options are
added, print the configuration report and store it with the machine log book. Discard any pre-
vious versions of the configuration report.
6. Remove and destroy any copies of test patterns.
7. Complete the machine service log, refer to GP 19
Service Log.
8. Ensure the machine and service area are clean before leaving the customer premises.
9. Provide customer training if required.
To Next Page
Loading...
Need help?
General
