General Procedures and Information
Phaser 3100 MFP 04/08 6-43
GP 13 Downloading the Software
Updating the machine software is principally carried out via a PC connection (USB only, see PC
connections, page 7).
The principal software which controls the card core and the miniboot software may be downloaded
separately.
Note: After downloading the principal software, the scanner may require calibration. Enter 8 0
and confirm by pressing OK. Wait until the screen refreshes and reverts to the default screen
mode. Make a local copy to check its quality.
Downloading via PC connection
Via the executable TELUSB2
This procedure requires a standard PC running under Windows and equipped with the
TELUSB2.exe (version 2.02) executable and a USB cable.
Before you start, position the bit n° 8 to 1 on the Soft-switch 1.
1. Connect the machine to a PC with the USB cable.
2. Set the machine to download via PC mode ( * 4).
3. Launch the executable TELUSB2.EXE
and select the file to be downloaded (extensions.bin
or.fwf).
After about ten seconds, a window will appear to indicate that the download was successful.
The machine should not be restarted immediately.
If the machine restarts immediately, the file is corrupted (checksum false) or the software is
not compatible with the machine. The machine then restarts with the initially installed soft-
ware. In this case, check the file and repeat step 1.
4. After about 40 seconds, the machine switches off then restarts. The message WAIT is dis-
played.
5. Check the version of the principal software and checksum by typing in * V or check the
software version and the miniboot’s checksum by typing in * B.
Via the Update Device function of Companion Suite
This procedure requires a standard PC running under Windows equipped with the Companion
Suite software and a USB cable.
Before you start, Check that the machine is connected to the PC via the USB cable.
1. On the PC, click START >ALL PROGRAMS >COMPANION SUITE >PHASER 3100 MFP >
UPDATE.
2. In the Update window, click on the BROWSE icon and select the update file to be down-
loaded on the machine.
3. After selecting the update file, click on OPEN.
4. Click on UPDATE.
To Next Page
Loading...
Need help?
General
