General Procedures and Information
6-24 04/08 Phaser 3100 MFP
GP 9 Environmental Conditions
When selecting the machine’s location, the following factors should be taken into consideration:
• The room should be adequately ventilated.
• A standard single-phase power socket with earth (rated in conformance with the information
on the label at the back of the machine) should be located no more than 2 meters (78
inches) from the machine. This socket should be easily accessible.
• For easy access to the machine and to allow the different machine covers to be opened eas-
ily, leave a space of at least 30 cm (12 inches) on each side and at the back. Make sure that
there is sufficient space in front of the machine.
• Never place the machine where it is under direct sunlight, heating radiators, air-conditioners,
Avoid areas with frequent vibrations.
• Avoid areas where water or other products may be splashed on to the machine.
• Never place the machine directly on the floor.
• Always place the machine on a sturdy, flat surface.
• Always keep the machine away from hanging objects and any inflammable products.
To Next Page
Loading...
