Xerox WorkCentre 5020 User Manual

System Settings
Xerox WorkCentre 5016/5020 User Guide 123
System Settings
The following procedure describes how to configure the system settings.
If the machine is in the No Account Mode
1) Proceed to Step 1 of the following procedure.
If the machine is in the Single Account Mode
1) Refer to "Logging in to the Machine" (P.68) to log in to the machine.
2) Proceed to Step 1 of the following procedure.
If the machine is in the Multiple Account Mode
1) Refer to "Logging in to the Machine" (P.69) to log in to the machine under the
System Administrator’s account.
2) Proceed to Step 1 of the following procedure.
1. Hold down the <Log In/Out> button for
four second.
The machine enters the System Setting
Mode.
The letter [P] appears blinking in the
Display.
2. Enter a menu number that you wish to configure using the numeric keypad in
reference to "System Setting List" (P.124).
3. Press the <Start> button to confirm the entered menu number.
The currently set value of the menu number appears blinking in the Display.
4. Enter a new value using the numeric keypad in reference to "System Setting List"
(P.124).
Note • Automatically erases the previously set value in the Display as you start entering a new
value.
<Log In/Out>
button

Xerox WorkCentre 5020 Specifications

General

Print Technology	Laser
Print Speed	Up to 20 ppm
Print Resolution	Up to 600 x 600 dpi
Max Paper Size	A3
Standard Paper Capacity	250 sheets
Bypass Tray Capacity	100 sheets
Duplex Printing	Manual
Copy Speed	Up to 20 cpm
First Page Out Time (Copying)	Less than 10 seconds
Scan Resolution	Up to 600 x 600 dpi
Operating System Compatibility	Windows, Mac OS
Automatic Document Feeder	50 sheets
Connectivity	USB 2.0
Functions	Print, Copy
Reduction / Enlargement	25% - 400%
Scan Destinations	USB, Email
Fax Transmission Speed	33.6 kbps
First Page Out Time (Printing)	Less than 8 seconds