Canceling a Copy Job
Xerox WorkCentre 5016/5020 User Guide 57
Canceling a Copy Job
The following procedure describes how to cancel a copy job.
1.
Press the <Stop> button.
Making Special Copies
This section explains how to make copies using the N-up feature and the ID Card copy
feature.
4-up/2-up Copies (Copying Multiple Pages onto a Single Sheet)
The following procedure describes how to copy multiples pages of documents onto one
side of a single sheet of paper.
1.
Press the <N-up/ID Card Copy> button
to select the N-up feature.
4-up
Copies four pages of the original documents onto one side of the
sheet.
2-up
Copies two pages of the original documents onto one side of the
sheet.
2.
Press the <Original Size> button to
select the original document size, and
load the document in reference to the
charts below.
Note • This button is selectable only when
using the Document Glass with the
N-up feature. The button is not
selectable when using the
Document Feeder as the size of
the original document is
automatically detected.
<Stop> button
<N-up/ID Card Copy>
button
<Original Size>
button
To Next Page
Loading...
