Xerox WorkCentre 5020 User Manual

Changing the Size and Orientation of Paper in the Trays
Xerox WorkCentre 5016/5020 User Guide 46
Changing the Size and Orientation of Paper in the Trays
This section describes how to replace paper in the trays with a different size and
orientation of paper, and how to specify the size and orientation of paper.
Note • When using non-standard size paper for a print job, load the paper in the Bypass Tray.
You must register the paper size in the print driver in advance.
For information on how to specify a custom paper size in the print driver, refer to
"Specifying the Custom Paper Size" (P.79).
Changing the Size and Orientation of Paper in Tray 1
The following procedure describes how to change the size and orientation of paper in
Tray 1.
1. Pull out Tray 1 towards you.
Note • While the machine processes a
job, do not pull out the tray in use.
2. Remove the remaining paper.
3. Push down the metal plate to the
bottom of the tray.
4. Slide paper guides towards the front
and back of the tray.

Xerox WorkCentre 5020 Specifications

General

Print Technology	Laser
Print Speed	Up to 20 ppm
Print Resolution	Up to 600 x 600 dpi
Max Paper Size	A3
Standard Paper Capacity	250 sheets
Bypass Tray Capacity	100 sheets
Duplex Printing	Manual
Copy Speed	Up to 20 cpm
First Page Out Time (Copying)	Less than 10 seconds
Scan Resolution	Up to 600 x 600 dpi
Operating System Compatibility	Windows, Mac OS
Automatic Document Feeder	50 sheets
Connectivity	USB 2.0
Functions	Print, Copy
Reduction / Enlargement	25% - 400%
Scan Destinations	USB, Email
Fax Transmission Speed	33.6 kbps
First Page Out Time (Printing)	Less than 8 seconds