Xinje XD5 - Interruption Flag of HSC; Setting Value Meaning in Absolute or Relative Mode

198
 When the interrupt is finished in a single execution, if it needs to start the interruption
again, the high-speed counter must be reset first, and then the driving condition must
be ON again.
 In interrupt loop mode, interrupts can be generated in sequence as long as M0 remains
on state.
5-9-4．Interruption flag of HSC
The 100 segments interruption flags of each HSC are in the following table. For example, the
100 segments interruption flags of HSC0 are I2000, I2001, I2002….. I2099.
HSC
Interruption flag
Segment 1
Segment 2
Segment 3
…
…
Segment N
Segment 100
HSC0
I2000
I2001
I2002
…
…
I（2000+N-1）
I2099
HSC2
I2100
I2101
I2102
…
…
I（2100+N-1）
I2199
HSC4
I2200
I2201
I2202
…
…
I（2200+N-1）
I2299
HSC6
I2300
I2301
I2302
…
…
I（2300+N-1）
I2399
HSC8
I2400
I2401
I2402
…
…
I（2400+N-1）
I2499
HSC10
I2500
I2501
I2502
…
…
I（2500+N-1）
I2599
HSC12
I2600
I2601
I2602
…
…
I（2600+N-1）
I2699
HSC14
I2700
I2701
I2702
…
…
I（2700+N-1）
I2799
HSC16
I2800
I2801
I2802
…
…
I（2800+N-1）
I2899
HSC18
I2900
I2901
I2902
…
…
I（2900+N-1）
I2999
5-9-5．Setting value meaning in absolute or relative mode
The setting value meaning is different in absolute and relative mode. Relative/absolute mode
can be set in the software panel. It can also be modified by special Flash register SFD330.
(Note: Driving conditions must be OFF and ON again to make the configuration effective.)
0: Relative mode;
1: Absolute mode.
 Relative mode