Xinje XD5 - Interruption Range’s Limitation; Interruption Forbidden

349
FEND
I4010
IRET
DI
EI
EI
SM070
FEND
I4020
IRET
END
M0
I48**
SM078
I58**
SM088
I49**
SM079
I59**
SM089
 Timing interruption is usually on ‘allow’ status.
 Can set interruption allow and forbidden area with EI、DI instructions. As shown in
below pictures, all timing interruptions are forbidden between DI and EI, and allowed
beyond DI~EI.
Interruption allowed
Interruption allowed
Interruption forbidden
Interruption forbidden
Interruption
Allowed
Interruption
Program
 The first 3CH timing
interruptions are equipped with
special relays (SM070~SM079).
 In the left example, if use M0 to
set SM070 “ON”, then forbid
timing interruption forbidden.
Interruption range’s limitation
Interruption Forbidden