328
When M0 is from OFF→ON, run ‘PLSR HD0 HD100 K1 Y0’ in the BLOCK to output the
pulse;
When M1 is from OFF→ON, suspend running the BLOCK, the pulse will stop slowly with
slope;
When M3 is from OFF→ON, output the rest pulses.
Please note that by the SBSTOP stops the pulse with slope, there may be still some pulses; in
this case, if run SBGOON K1 K0 again, it will output the rest of the pulses.
9-7．BLOCK flag bit and register
1. BLOCK flag bit:
To Next Page
Loading...
