Xinje XD5 - Page 203

202
When continuous loop interruption is performed (without cam function enabled), interrupts
occur in the following order:
Segment 1
interruption
Segment 2
interruption
Segment 3
interruption
Segment N
interruption
The last
segment
interruption
Via setting SFD331, users can switch between single loop mode or continuous loop mode.
The detailed assignment is show below:
(Note: the settings will be effective after setting OFF and ON the driving condition again)
Address
HSC
Setting
Bit0
100 segments HSC interruption cycle (HSC0)
0: single loop
1: continuous loop
Bit1
100 segments HSC interruption cycle (HSC2)
Bit2
100 segments HSC interruption cycle (HSC4)
Bit3
100 segments HSC interruption cycle (HSC6)
Bit4
100 segments HSC interruption cycle (HSC8)
Bit5
100 segments HSC interruption cycle (HSC10)
Bit6
100 segments HSC interruption cycle (HSC12)
Bit7
100 segments HSC interruption cycle (HSC14)
Bit8
100 segments HSC interruption cycle (HSC16)
Bit9
100 segments HSC interruption cycle (HSC18)