250
2. Set the parameters by using XINJEConfig tool
When using configuration tool XINJEConfig to configure parameters of PLC serial port, the
XINJEConfig tools of V1.6.308 and below must use USB port. The XINJEConfig tool for
V1.6.309 and above can also be configured using RS232 port.
(1) Use the USB download cable to connect the PLC with the computer. Here the USB
download cable is the HMI download cable, as shown below.
(2) Open xinjeconfig tool
(3) Click config/find device:
(4) Choose the com port connecting PC and PLC, click ok. Click config/single
device/comport.
To Next Page
Loading...
