292
7. The final heating temperature will up to 110 degree when the overshoot is permitted. It is
over the target temperature by 50 degree, the overshoot amount is too large.
8. When the PID starts to work, the output will heat the object from 28 degree to 60 degree,
then the output is forced to stop heating to avoid overshoot, but this will interrupt the PID
auto tune process.
9. To enlarge the PID calculation range can suppress the heating overshoot.
Overshoot is not permitted:
1. The target temperature is 60 degree (600)
2. The related parameter settings:
3. The result curve
To Next Page
Loading...
