Xtreamer e-TRAYz - Page 100

100
If you want to use a wireless LAN
• Connect to a USB port a USB wireless device compatible with the product. (the upper is USB 2.0 and the lower
is USB 1.1)
• Set wireless network at [Settings] – [System] – [Wireless Network] page.
• As the wireless is slower and less stable than the wired LAN, use the latter if possible.
When you want to back up a USB flash drive
• Insert a flash drive into a USB port.
• Click the COPY button on the front for 1 second. The copy start with a single beep.
• The files in the flash drive are copied to Public Disk / USB_copy’ folder.
• The copied files are generated with the current time and the same file names
• A single beep will ring when the copy is completed.
• If the disk is out of space, the copy failed with double beep.
• During the copy, this button is pressed for 3 sec and released the copy stopped with double beep.
If you want to expand the disk capacity with an external USB disk
• Connect a external USB disk to a USB port(The upper is USB 2.0 and the lower is USB 1.1)
• If it is connected to the upper, it is mounted on ‘USB 1’, or if it is connected to the lower, it is mounted on ‘USB
2’ in External Disk.
• Any partitions in the disk will show up as part01, ….partN, in order.
If you want to keep the data safe
• The device supports the RAID 1 mirroring mode.
• Choose the mirroring mode at the time of installation if you keep the data in the disk safe.
• The mirroring mode is only meaningful when you have two separate disks.
•
Even when you installed in a single disk but want to add another disk later on, you can expand the disk with
the disk manager to build a mirroring.
• In the mirroring, a single set of data is written on two disks for added safety.
• When one disk is in error, you can fetch the date from the other disk.
• However, unlike the linear (expansion) mode, the mirroring mode slows down the speed of writing on the disk
and lets you use only half the total physical disk space.
If you want to make a connection with a fixed name not IP Address
• Move to [Settings]-[System]-[Wired Network] page and find the DDNS part.
• Set any name you desire. (OOO.myetrayz.net)
•
When the settings is complete, you can access with the name via internet. However, if the devices is hooked to
a IP sharer, make sure that you set DMZ or Portforwarding on the IP sharer.
• When the IP address of the IP sharer changes, you need to up date the address with the DDNS manage of the
system administrator.