105
Trouble Shooting
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not
open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before
taking the system for repair.
In case Xtreamer e-Tayz cannot be accessed via Network
• Check network status and if network port is correctly connected.
• Check if access to Xtreamer e-TRAYz is blocked by firewall, etc.
• In case IP is not known, refer to 2) below.
• In case network setup is incorrect, refer to 3) below.
• If not falling within the previous points o
f 2) and 3) below, check for abnormalities in LED operation by
checking LED status at the front of equipment.
• Request technical support if LED does not operate normally.
2) In case access is not possible due to forgetting IP address of Xtreamer e-TRAYz.
•
A WindowsXp or higher comes with a function to find a UPnP device in the network environment. If the UPnP
is not active, activate it.
• The name of this device is searched automatically.
• Click this device and the web browser will start, getting the web page of this device. You can get the IP address
from the address of the web page.
3) In case access to Xtreamer e-TRAYz is not possible at all due to incorrect network setup
• Click Reset button on the rear of device until the single beeping
• The network initialization is completed with 2 beeps.
• For the initialized network IP, refer to the section of network setting in manual.
4) Does not recognize Hard Disk(not turned off the RED LED)
• Make sure that the Hard disk is mounted the exact location.
• Please fix the HDD exactly.
To Previous Page
Loading...