20
Router Setting
- Connect the e-TRAYz to a router or modem via a LAN cable.
- Select one of two following options.
1. Using router's UPnP function.
(1) Login to your router and activate the UPnP function.
(2) Log out.
(3) Login to e-TRAYz main menu page and go to [Setup Wizard]-[Router] menu.
(3) Select ‘Use router's UPnP function’ button.
(4) Click ‘Go to UPnP setup’ button then UPnP setting page will appear.
(5) Mark ‘Activate router port mapping function using UPnP’ checkbox and then click 'Change Setup' button.
Then you will see Port mapping settings.
(5) Enter a port number you want and click ‘Apply’ check box and 'Change Setup' button.
(6) Log out of e-TRAYz.
UPnP port mapping function may not work in following cases.
• If router does not support UPnP protocol
• If router's UPnP IGD can not communicate with e-TRAYz UPnP Client.
• Router may loose mapping information after a reboot. In this case you will need to configure it again.
2. Using router’s DMZ or Port Forwarding(virtual server) function.
(1) Login to your router.
(2) For DMZ go to DMZ setup Menu. You may need to activate your router's Firewall first.
- enter IP address of e-TRAYz to IP input box.
(3) For Port Forwarding(Virtual Server),go to Port Forwarding setup menu.
- enter IP address of e-TRAYz to IP input box.
- enter port number used by e-TRAYz to port input box.
- enter protocol to protocol input box.
(4) Log out.
Function Protocol Port Number
Private Homepage TCP 8000
e-TRAYz Home TCP 8080
To Next Page
Loading...