Yaesu FT-710 - Page 93

MIC SCAN RESUME
Function: Sets the Scan Resume function.
Available Values: PAUSE / TIME
Default Setting: TIME
Description:
PAUSE: During automatic scanning, the scanner
will hold until the signal disappears.
TIME: If the signal does not disappear within
five seconds, the scanner will resume
scanning for the next active channel
(frequency).
If there are no signals, the scanner con-
tinues scanning.
REF FREQ FINE ADJ
Function: Adjusts the reference oscillator.
Available Values: -25 - 0 - 25
Default Setting: 0
Description: The frequency may be calibrated
by connecting a frequency counter
to the transceiver, or by receiving a
standard frequency such as WWV or
WWVH.
KEYBOARD LANGUAGE
Function: Selects the keyboard language.
Available Values: JAPANESE / ENGLISH(US)
ENGLISH(UK) / FRENCH
FRENCH(CA) / GERMAN
PORTUGUESE
PORTUGUESE(BR)
SPANISH / SPANISH(LATAM)
ITALIAN
Default Setting: Depends on the transceiver ver-
sion.
MIC P1 / P2 / P3 / P4
Function: The functions of the [P1] / [P2] / [P3]
/ [P4] keys can be assigned the other
functions.
Available Values: LOCK / QMB / A/B / V/M /
TUNER / VOX/MOX / MODE /
ZIN_SPOT / SPLIT / FINE /
NAR / NB / DNR / FREQ UP /
FREQ DOWN / BAND UP /
BAND DOWN / ATT / IPO /
DNF / AGC
Default Setting: MIC P1: LOCK
MIC P2: QMB
MIC P3: A/B
MIC P4: V/M
Description:
LOCK: Toggles the ON/OFF lock for the
MAIN Dial knob.
QMB: QMB (Quick Memory Bank) function.
A/B: Swaps the VFO-A and VFO-B
frequency data.
V/M: Toggles frequency control between
VFO and the memory system.
TUNER: Turns the built-in antenna tuner ON/
OFF .
VOX/MOX: Press to turn the VOX function ON/
OFF. Press and hold to activate the
MOX function.
MODE: Change the operation mode.
ZIN SPOT: Press to activate the auto-zero
function. Press and hold to activate
the sidetone.
SPLIT: SPLIT function.
FINE: Sets the ne tuning ON/OFF.
NAR: Sets the Narrow ON/OFF.
NB: Activates the NB (Noise blanker)
function.
DNR: Activates the DNR (Digital Noise
Reduction) function.
FREQ UP: Change to a higher frequency.
FREQ DOWN:
Change to a Lower frequency.
BAND UP: Change to a higher Operation Band.
BAND DOWN:
Change to a Lower Operation Band.
ATT: Turns the ATT (Attenuator) ON/OFF.
IPO: Activates the IPO.
DNF: Turns the DNF (Digital Notch Filter)
ON/OFF.
AGC:Adjust the AGC receiver-recovery time.
MIC UP / MIC DOWN
Function: The functions of the [UP] / [DWN] keys
of the supplied microphone can be as-
signed the other functions.
Available Values: Same as MIC P1 to MIC P4 on
the left.
Default Setting: UP: FREQ UP
DWN: FREQ DOWN
Description: Same as MIC P1 to MIC P4 on the
left.
SCU-LAN10
Function: Selects the use of the LAN unit “SCU-
LAN10”.
Available Values: OFF / ON
Default Setting: ON
Description:
ON: When using the SCU-LAN10.
OFF: When not using the SCU-LAN10.
91