Yaesu FT-710 - Page 98

TX INHIBIT
Function: Enable/Disable the TX INHIBIT func-
tion.
Available Values: OFF / ON
Default Setting: OFF
Description:
ON: Enable the TX INHIBIT function.
OFF: Disable the TX INHIBIT function.
METER DETECTOR
Function: Setting of the PO meter display.
Available Values: AVERAGE / PEAK
Default Setting: AVERAGE
Description: Select the transmit power output in-
dication method.
AVERAGE: Displays the average transmit power.
(Even if the transmit power is 100W,
the meter rarely swings to 100W.)
PEAK: Displays the maximum transmit
power. (When the transmit output
power is 100W, the meter swings up
to 100W.)
OPERATION SETTING
- TUNING -
SSB/CW DIAL STEP
Function: Setting of the MAIN dial tuning speed
in the SSB and CW mode.
Available Values: 5 / 10 / 20 (Hz)
Default Setting: 20kHz
RTTY/PSK DIAL STEP
Function: Setting of the Main dial knob tuning
speed in the RTTY and PSK mode.
Available Values: 5 / 10 / 20 (Hz)
Default Setting: 10kHz
CH STEP
Function: Selects the tuning steps for the Main
dial knob.
Available Values: 1 / 2.5 / 5 / 10 (kHz)
Default Setting: 5kHz
AM CH STEP
Function: Selects the tuning steps for the Main
dial knob in the AM mode.
Available Values: 2.5 / 5 / 9 / 10 / 12.5 / 25 (kHz)
Default Setting: 5kHz
FM CH STEP
Function: Selects the tuning steps for the Main
dial knob in the FM mode.
Available Values: 5 / 6.25 / 10 / 12.5 / 20 / 25 (kHz)
Default Setting: 5kHz
MAIN STEPS PER REV.
Function: Setting the steps per rotation of the
MAIN dial.
Available Values: 50 / 100 / 200
Default Setting: 200
96