Yaesu FT-710 - Page 99

DISPLAY SETTING
- DISPLAY -
MY CALL
Function: Programs a Call Sign or Name.
Available Values: Up to 12 alphanumeric charac-
ters
Default Setting: FT-710
Description: Set characters to be displayed on
the power ON opening screen.
MY CALL TIME
Function: Set the time for displaying characters
registered in “MY CALL”.
Available Values: OFF / 1 / 2 / 3 / 4 / 5 (sec)
Default Setting: 1sec
Description: Set the time “My Call is displayed on
the opening screen after power ON.
POP-UP TIME
Function: Sets the display time of the pop-up
screen when setting various functions
Available Values: FAST / MID / SLOW
Default Setting: MID
Description:
FAST: Pop-up screen display time is shorter
than normal.
MID: Pop-up screen display time is normal.
SLOW: Pop-up screen display time is longer than
normal.
SCREEN SAVER
Function: Time setting before the screen saver to
activate.
Available Values: OFF / 15 / 30 / 60 (min)
Default Setting: 60min
Description: If the transceiver is not operated for
the set time, a screen saver will acti-
vate to prevent TFT screen burns.
LED DIMMER
Function: Sets the key LED brightness level.
Available Values: OFF / 1 - 20
Default Setting: 20
Description: The higher the setting, the brighter
the illumination becomes.
Note: the power switch, [VOX/MOX], and the
BUSY/TX LEDs will remain ON, even
when the brightness level is set to OFF.
MOUSE POINTER SPEED
Function: Mouse pointer movement speed set-
ting.
Available Values: 0 - 20
Default Setting: 10
Description: The higher the setting, the faster the
Mouse pointer will move.
DISPLAY SETTING
- SCOPE -
RBW
Function: Sets the resolution of Spectrum Scope
display.
Available Values: HIGH / MID / LOW
Default Setting: HIGH
Description: When set to HIGH, the image is
nely divided.
SCOPE CTR
Function: Sets the scope screen center and
marker position.
Available Values: FILTER / CARRIER
Default Setting: CARRIER
Description:
FILTER: Relative to the center of the lter.
CAR POINT: Based on signal carrier points.
2D DISP SENSITIVITY
Function: Change the Waterfall Display sensitiv-
ity.
Available Values: NORMAL / HI
Default Setting: HI
Description:
NORMAL: Display at normal sensitivity.
HI: Display at high sensitivity.
3DSS DISP SENSITIVITY
Function: Change the 3DSS Display sensitivity.
Available Values: NORMAL / HI
Default Setting: HI
Description:
NORMAL: Display at normal sensitivity.
HI: Display at high sensitivity.
97